Full Version: What is C V V 2? (Sticky)
From: Harvey only (HARVEY-ONLY) [#23]
23 Jun 2006
To: Cindy (CINDYM) [#22] 23 Jun 2006
It all depends on your processor company.
We happen to have a different supplier for the two locations, one requires the manual input of the last four digits of the card, the other does not.
From: Joe (SMITTY61) [#24]
1 Feb 2007
To: Trophyman [#21] 16 Feb 2007
From: Engravin' Dave (DATAKES) [#25]
1 Feb 2007
To: Joe (SMITTY61) [#24] 1 Feb 2007
Joe,
You are correct, but the number on the back of the card could be 3 or 4 numbers.
http://www.expressionsengraved.com
EDITED: 4 Jul 2010 by DATAKES
From: Joe (SMITTY61) [#26]
1 Feb 2007
To: Engravin' Dave (DATAKES) [#25] 1 Feb 2007
Yep... The last 3 or 4 numbers on the back is the "V" code.
Thanks for clarifying that :>
From: Ron (RBENNETT) [#27]
8 Apr 2007
To: Rob (AWARDZZ) [#7] 9 Apr 2007
Robert, I have a Meistergram 1912 with an extra controller for parts.
Would you be interested in purchasing it? It runs fine. I do not have any software so I have been running it off Engravelab. I am located in Ann Arbor Mich.