Full Version: Gold Embossing

From: Stunt Engraver (DGL) [#11]
 23 Feb 2006
To: MR C (MOSHE) [#10] 23 Feb 2006

Mr. C,

I haven't seen the Signature attachment, to know how it works.

Traditionally, gold foil is placed under a heated die, which is applied to the leather with pressure, releasing gold foil in the image of the die.

---

From: MR C (MOSHE) [#12]
 23 Feb 2006
To: Stunt Engraver (DGL) [#11] 23 Feb 2006

I think there is a heated shank that takes the place of the cutter

---

From: PenTrophy (PENINSULATROPHY) [#13]
 23 Feb 2006
To: MR C (MOSHE) [#10] 23 Feb 2006

Here is an attachment Newing-Hall used to carry.......maybe it will give you some ideas..

EDITED: 19 Feb 2007 by PENINSULATROPHY

---

From: MR C (MOSHE) [#14]
 23 Feb 2006
To: PenTrophy (PENINSULATROPHY) [#13] 23 Feb 2006

Whoa!! You guys are great!!!

This forum is faster than a phone call!!

Do you know if this was a cost/labor/time/quality effective piece?

---

From: PenTrophy (PENINSULATROPHY) [#15]
 23 Feb 2006
To: MR C (MOSHE) [#14] 23 Feb 2006

Like all after market attachments that are rigged to run on someone elses machine, getting the feed rate, heat level and pressure correct would be an ever challenging venture. In otherwords, I don't know........... they did not sell very many I would sepculate, because the letter presses were big when they introduced the attachment.

---

From: Stunt Engraver (DGL) [#16]
 23 Feb 2006
To: PenTrophy (PENINSULATROPHY) [#13] 23 Feb 2006

Mark,

Pretty slick. I'd never seen that before.

---

From: Stunt Engraver (DGL) [#17]
 23 Feb 2006
To: MR C (MOSHE) [#14] 23 Feb 2006

We tried to warn you, through the start page. We take our slogan very seriously. :-) 

---

From: MR C (MOSHE) [#18]
 23 Feb 2006
To: Stunt Engraver (DGL) [#17] 23 Feb 2006

But we did not take the warning that seriously

---

From: Stunt Engraver (DGL) [#19]
 23 Feb 2006
To: MR C (MOSHE) [#18] 23 Feb 2006

Mr. C,

We have no control over that. All we can do is put the "truth in advertising" out there. :-) 

---

Show messages: All  1-10  11-19

Back to thread list | Login

© 2024 Project Beehive Forum