Full Version: Changing default text units
From: Griffo (LASERWEST) [#11]
15 May 2006
To: Mike (MIKEN) [#10] 15 May 2006
Hi Mike.
I just doing what you suggested and came up with the following.
Typed in lower case v at 270points which shows up as 49.4mm in the height box.
When I go to Text - Format Text the height in mm shows up as 95.25mm. I then drew a box at 50mm height (to check which measurement was right and low and behold it was the height in the height box 49.4mm. I've got no idea how the text - text format text got it to 95.25mm
ARgggggggggghhh :-)
Dave
From: Mike (MIKEN) [#12]
15 May 2006
To: Griffo (LASERWEST) [#11] 15 May 2006
Have you tried the Corel newsgroup, cnews.corel.com. Join that group and post your question there.
I'm stumped on this as well.
EDITED: 15 May 2006 by MIKEN
From: jeff (JCHUMBLEY) [#13]
15 May 2006
To: Mike (MIKEN) [#12] 15 May 2006
Yahoo groups has an awesome corel user group. CDUG. They can answer just about anything that you can think of.
Jeff
From: Mike (MIKEN) [#14]
15 May 2006
To: jeff (JCHUMBLEY) [#13] 15 May 2006
Jeff
Thank you.
I'll check them out.
Mike
From: Griffo (LASERWEST) [#15]
15 May 2006
To: Mike (MIKEN) [#12] 19 May 2006
Thanks Mike, I'll give that a try
Regards
Dave
From: Griffo (LASERWEST) [#16]
15 May 2006
To: jeff (JCHUMBLEY) [#13] 15 May 2006
Hi Jeff,
I'll give a try also.
Thanks to all for your help
Regards
Dave