Full Version: Two layer plates
From: Lynn (LYNNDENO) [#5]
23 Oct 2006
To: Dave Jones (DAVERJ) [#4] 24 Oct 2006
Hi Dave , That sounds like a good idea. I will try to do that in morning.
I also liked the tape idea and the marker,
Thank You everyone that gave me the tips.
And yes this forum really is awesome.
Lynn
From: Shaddy [#6]
26 Oct 2006
To: Lynn (LYNNDENO) [#5] 26 Oct 2006
I use Dave's idea for alignment. I usually create a template out of 1/8 MDF or birch. I have even made a template to use with my router (pattern following bit) on my laser. I needed to stack and glue the MDF though, because I needed 3/4 depth. I also used 1/4" acrylic because I ran out of MDF.
MDF is cheap enough, I use it for templates and for practicing (to see if I did alignments right)
Shaddy