Full Version: Birth Certificate Holder
From: Stunt Engraver (DGL) [#8]
16 Nov 2006
To: Engravin' Dave (DATAKES) [#7] 16 Nov 2006
Thank you David.
Is there enough resistance in the rubber, to keep a part from "squirming" if a lot of pressure (drag) were introduced?
EDITED: 16 Nov 2006 by DGL
From: Engravin' Dave (DATAKES) [#9]
16 Nov 2006
To: Stunt Engraver (DGL) [#8] 16 Nov 2006
It is a fairly hard rubber. I can use full tension on my IS400 without much play. The ability of the item you are engraving to withstand a moderately strong vice clamp helps.
David Takes
Expressions Engraved
Acrylic Awards, Crystal Trophy, Glass Award, Plaques
http://www.expressionsengraved.com
EDITED: 7 Aug 2010 by DATAKES