Full Version: New Hermes fonts on Gorton 3u machine
From: laserman (MIKEMAC) [#2]
28 Dec 2006
To: logojohn [#1] 28 Dec 2006
LJ,
Going back into time here, If I recall when I used to use the gorton there was a tray that accepted the large type in the top section and the small type in the lower center section. I don't know for sure if yours is set-up that way but the one I worked with was.
EDITED: 28 Dec 2006 by MIKEMAC
From: Stunt Engraver (DGL) [#3]
28 Dec 2006
To: logojohn [#1] 28 Dec 2006
It's been a long time since I've used a Gorton, but from what I can remember, the template area was a flat "plate", to which typical type slides can be affixed.
From: logojohn [#4]
29 Dec 2006
To: Stunt Engraver (DGL) [#3] 29 Dec 2006
I figured it might be something like that but haven't ever seen one up close.
Somebody with the gorton asked me as I am selling off our pantograph fonts I no longer use on eby.
From: Stunt Engraver (DGL) [#5]
29 Dec 2006
To: logojohn [#4] 29 Dec 2006
If the Gorton guy doesn't take all the type, you may want to list the ebay link here. (Ad/Buy/Sell folder)
From: logojohn [#6]
29 Dec 2006
To: Stunt Engraver (DGL) [#5] 29 Dec 2006
I was going to mention it here this weekend since
the first auctions are ending in a few days.
There are more engraving fonts than most people would need.
I think he must be just getting started since he just asked me
what a flx cutter was :/ .
To be legit I will add it to the buy sell folder!
Thanks
EDITED: 29 Dec 2006 by LOGOJOHN
From: UncleSteve [#7]
29 Dec 2006
To: logojohn [#6] 29 Dec 2006
what a flx cutter was
Not to be confused with a GPY????? ;-)
From: rj (RANDYJOYCE) [#8]
3 Jan 2007
To: logojohn [#1] 3 Jan 2007