Full Version: Corel vs Illustrator
From: LaZerDude (C_BURKE) [#27]
14 Apr 2007
To: Larry B (PALMETTO) [#26] 14 Apr 2007
Thanks Larry,
This thread has been enlightening to say the least.....it is great that so many folks shared their opinions and ideas..... I learned a lot......
From: Pedaler (ROYBREWER) [#28]
14 Apr 2007
To: Mike (MIKEN) [#25] 14 Apr 2007
Sounds like a terrific project. I hope you'll be able show the finished model. When are the "real" gates scheduled to be completed?
From: Mike (MIKEN) [#29]
14 Apr 2007
To: Pedaler (ROYBREWER) [#28] 15 Apr 2007
I have sent a request for a picture to the artist. The installation should be completed in June.
The model was made at the request of the donor of the steel for the gates.
I will follow up on this even if I have to take pictures of the real thing once installed.
From: William Desrochers (DRAKESIS) [#30]
15 Apr 2007
To: LaZerDude (C_BURKE) [#1] 15 Apr 2007
Illustrator CS can open CDR 10 and under files, as CMYK or RGB.
I use both Illustrator CS and Coreldraw 12, and honestly there's not a lot of difference between both. There both just as good for vectoring.
From: LaZerDude (C_BURKE) [#31]
15 Apr 2007
To: William Desrochers (DRAKESIS) [#30] 15 Apr 2007
Thank you William,
I appreciate your input. The conclusion I have come to is to Keep on using X3 and upgrade Photoshop.
I will try some of the tricks mentioned here regarding pre processing as well.....
Thanks again for your help.