Full Version: Fiberglass Settings?

From: Vicky (ANDERI) [#5]
14 Apr 2007
To: Vicky (ANDERI) [#1] 14 Apr 2007

Well, we gave it a shot. Lovely black pool cue. The laser ended up "frosting" the top layer of the finish, I believe. The result was a nice, crisp, white text on a black cue. Bottom line, it worked well, took about 5 minutes including set-up, the customer was thrilled, and I didn't have to replace a $200 cue. :-)

From: Hermes (HERMESSANDOVAL) [#6]
14 Apr 2007
To: Vicky (ANDERI) [#5] 14 Apr 2007

It's good to hear it came out right. I'm engraving 500+ pieces of kitchen utensils right now and most of them are covered with graphite, like this setup you've just described, it looked like it could go really wrong, but ended up engraved very nice in less than 3 minutes, setup not included.

Keep on experimenting, learning never stops with lasers.

From: Dave Jones (DAVERJ) [#7]
14 Apr 2007
To: Vicky (ANDERI) [#5] 14 Apr 2007

Excellent!

Show messages: All 1-4 5-7

Full Version: Fiberglass Settings?

Back to thread list | Login

© 2024 Project Beehive Forum