Full Version: Fiberglass Settings?
From: Hermes (HERMESSANDOVAL) [#6]
14 Apr 2007
To: Vicky (ANDERI) [#5] 14 Apr 2007
It's good to hear it came out right. I'm engraving 500+ pieces of kitchen utensils right now and most of them are covered with graphite, like this setup you've just described, it looked like it could go really wrong, but ended up engraved very nice in less than 3 minutes, setup not included.
Keep on experimenting, learning never stops with lasers.
From: Dave Jones (DAVERJ) [#7]
14 Apr 2007
To: Vicky (ANDERI) [#5] 14 Apr 2007