Full Version: Looking For Metal Blanks
From: RALLYGUY (RALLYGUY1) [#7]
17 Apr 2007
To: Harvey only (HARVEY-ONLY) [#6] 17 Apr 2007
Minimums are normaly down to 1 piece, but the programming charges get ya ;)
Waterjet cuts typicaly leave a bad burr on thin stock aluminum....Harder metals aren't too bad though.
From: RALLYGUY (RALLYGUY1) [#8]
17 Apr 2007
To: Don (HIGHDESERT) [#5] 17 Apr 2007
Thanks for the reply....
Sorry it wasn't a good match this time.
From: Harvey only (HARVEY-ONLY) [#9]
17 Apr 2007
To: RALLYGUY (RALLYGUY1) [#7] 17 Apr 2007
From: Stunt Engraver (DGL) [#10]
17 Apr 2007
To: Don (HIGHDESERT) [#1] 17 Apr 2007
Identification Plates has a wide variety of dies for fabricated metal plates.
http://www.idplates.com/cf1.html
Low set up charges and minimums.
From: RALLYGUY (RALLYGUY1) [#11]
17 Apr 2007
To: Stunt Engraver (DGL) [#10] 17 Apr 2007
From: Stunt Engraver (DGL) [#12]
17 Apr 2007
To: RALLYGUY (RALLYGUY1) [#11] 17 Apr 2007
That's true. The company has a long history in die cut metal, but it may be limited to smaller pieces.