Full Version: Oh Oh! What's happening here?
From: Harvey only (HARVEY-ONLY) [#14]
18 Apr 2007
To: Mike (MIKEN) [#13] 18 Apr 2007
I do not have that problem at all. I occasionally do rounded corner tags. I find your problem alien to me so I gave you something that might help. Normally Corel starts at the end of a rounded corner and comes back to it. It is puzzling to me that it happens, but others here report the same thing.
I do not have air assist but have a very large amount of air going over the surface through the exhaust. It is rare after 8 hour of lasering that I have to clean the lenses. I check and clean them anyway but it is a rare occasion that I can see anything on them. (Of course when I forget to turn on the blower, it is a mess in 5 seconds and desperately needs cleaning.)
From: Mike (MIKEN) [#15]
18 Apr 2007
To: Harvey only (HARVEY-ONLY) [#14] 18 Apr 2007
I will try your suggestion. Keep in mind I do not perceive this to be a problem.
When you do an item like this where does your machine start and stop.?
From: Harvey only (HARVEY-ONLY) [#16]
18 Apr 2007
To: Mike (MIKEN) [#15] Unread