Full Version: Hot Stamping Learning Curve
From: Stunt Engraver (DGL) [#8]
19 Mar 2005
To: LaZerDude (C_BURKE) [#7] 19 Mar 2005
Chuck,
I haven't heard of the Howard JP 80, but then again, Howard hasn't heard of me either :-)
Actually, there's very little difference between hot stamping machines, other than, some have larger printing fields, can reach higher temps and offer the added convenience and consistency of pneumatic (air actuated) operation, which lessens the fatigue of the operator.
Hand operation of hot stamp machines requires an acquired "touch." Dwell time, heat and pressure can vary from item to item.
I feel it's good to know the physical "feel" of those variables, in order to understand the settings of the pneumatic equipment.
It's similar to knowing how to operate a manual pantograph. Being able to physically "feel" the drag of a cutter (diamond-drag or rotary), through various substrates, makes setting feed rates, dwell time and depth of cut on computerized equipment much easier.
That way, you're working from actual feedback of the manually operated equipment, to logically make the proper settings.
Profitability? That depends on the jobs you do. Very few people want to deal with aftermarket marking of customer supplied goods. If you gain enough experience to conquer that "Fear Factor" there's good money to be made on 1z-2z's.
Other than that, your best bet is to get pneumatic equipment and go for higher volume, less risky buisness.
There's a company in Sun Valley, CA, who in the past, has shown interest in forum participation. AAMSTAMP, is the company who basically filled the void left by Kingsley (old-line supplier of hot stamping equipment and supplies) when they closed their doors a few years back.
I asked about a field trip, for forum members, and they seemed open to the idea.
I'll give them a call and see if they have anything to add to this thread.
David "The Stunt Engraver" Lavaneri
DGL Engraving
Port Hueneme, CA
From: Harvey only (HARVEY-ONLY) [#9]
21 Mar 2005
To: LaZerDude (C_BURKE) [#7] 21 Mar 2005
Others do it well but my Kingsley machine has been sitting in my garage for about 7 years unused with about 8 fonts. I do not wish to sell it, yet.
It is a market that I have not gone into due to the setup time and the non-expertise I have. I need a sample piece to play with to get the right settings, and do not usually have that luxury. I have done napkins and ribbons and an occasional other item. I do not have any true gold foil so I would not even try leather. (Brass foil turns green very fast due to the tannic acid in leather.)
From: Stunt Engraver (DGL) [#10]
21 Mar 2005
To: Harvey only (HARVEY-ONLY) [#9] 21 Mar 2005
Harvey,
In absence of true gold foil, there are crossover foils that come very close in appearance, and adhere to leather very well.
The small Kingsley machine you own can be used to place single color logos on plastic namebadges. Multiple colors are possible, but the registration is more hassle than it's worth, for a short run.
David "The Stunt Engraver" Lavaneri
DGL Engraving
Port Hueneme, CA