Gold Embossing - Engraving Etc. Forum

Press Ctrl+Enter to quickly submit your post

Quick Reply

✏✏✏✏✏✏✏✏✏✏

From:	MR C (MOSHE)	23 Feb 2006
To:	Stunt Engraver (DGL)	12 of 19

2936.12 In reply to 2936.11
I think there is a heated shank that takes the place of the cutter

From:	PenTrophy (PENINSULATROPHY)	23 Feb 2006
To:	MR C (MOSHE)	13 of 19

2936.13 In reply to 2936.10
Here is an attachment Newing-Hall used to carry.......maybe it will give you some ideas.. .... ... .. . Mark In the Great Northwest!
EDITED: 19 Feb 2007 by PENINSULATROPHY

From:	MR C (MOSHE)	23 Feb 2006
To:	PenTrophy (PENINSULATROPHY)	14 of 19

2936.14 In reply to 2936.13

Whoa!! You guys are great!!!

This forum is faster than a phone call!!

Do you know if this was a cost/labor/time/quality effective piece?

From:	PenTrophy (PENINSULATROPHY)	23 Feb 2006
To:	MR C (MOSHE)	15 of 19

2936.15 In reply to 2936.14
Like all after market attachments that are rigged to run on someone elses machine, getting the feed rate, heat level and pressure correct would be an ever challenging venture. In otherwords, I don't know........... they did not sell very many I would sepculate, because the letter presses were big when they introduced the attachment. .... ... .. . Mark In the Great Northwest!

From:	Stunt Engraver (DGL)	23 Feb 2006
To:	PenTrophy (PENINSULATROPHY)	16 of 19

2936.16 In reply to 2936.13
Mark, Pretty slick. I'd never seen that before. David "The Stunt Engraver" Lavaneri DGL Engraving Port Hueneme, CA

From:	Stunt Engraver (DGL)	23 Feb 2006
To:	MR C (MOSHE)	17 of 19

2936.17 In reply to 2936.14
quote: Whoa!! You guys are great!!! This forum is faster than a phone call!! We tried to warn you, through the start page. We take our slogan very seriously. :-) David "The Stunt Engraver" Lavaneri DGL Engraving Port Hueneme, CA

From:	MR C (MOSHE)	23 Feb 2006
To:	Stunt Engraver (DGL)	18 of 19

2936.18 In reply to 2936.17
But we did not take the warning that seriously

From:	Stunt Engraver (DGL)	23 Feb 2006
To:	MR C (MOSHE)	19 of 19

2936.19 In reply to 2936.18
Mr. C, We have no control over that. All we can do is put the "truth in advertising" out there. :-) David "The Stunt Engraver" Lavaneri DGL Engraving Port Hueneme, CA

Show messages: All 1-11 12-19

Adjust text size: Smaller 10 Larger

Beehive Forum 1.0.1 | FAQ | Docs | Support | Donate!

Forum Stats