New Hermes IS400 - Engraving Etc. Forum

<body> <h1>Full Version: <a href="https://www.engravingetc.org:443/archive/index.php?webtag=EE&msg=3637.1">New Hermes IS400</a></h1><a name="a3637_1"></a><p><b>From: Harvey only (HARVEY-ONLY)</b> [<a href="lmessages.php?webtag=EE&msg=3637.1">#1</a>]<br /> 26 Apr 2006<br /><b>To: ALL</b></p> <p>I intended to post this years ago but forgot. A post I just made in another thread brought it to mind.</p> <p>In the IS400 controller, there was a minor mistake in assembly, that can cause a major problem.</p> <p>The fans in the rear are exhaust fans, the air filter, (the grey foam), should be removed. They will clog and still look just fine. The true air filter is located in rectangular holes just under the front edge. These need to be vacuumed often.</p> <p>Failure to remove the extra filters or vacuum the real filter can lead to controller overheat and failure.</p><p class="edit_text">EDITED: 26 Apr 2006 by HARVEY-ONLY</p> <hr /><h4><a href="lthread_list.php?webtag=EE">Back to thread list</a> | <a href="llogout.php?webtag=EE">Login</a></h4> <h6>© 2024 <a href="http://www.beehiveforum.net/" target="_blank">Project Beehive Forum</a></h6> </body>